Headgear for Amara View Full Face CPAP Mask

Yes, both the Amara View Mask frame and Amara View Headgear are only available in one size, so your replacement headgear will seamlessly attach to your mask frame the same way your original headgear did. The only size difference is in the mask cushion, which is available in Small, Medium, and Large.

Yes, the Amara View Headgear uses headgear clips to fasten the headgear to the mask frame. These clips are included with your mask purchase and easily snap into place or twist off to disconnect your mask.

There are two telltale signs to look out for that will indicate it is time for you to replace the headgear on your CPAP mask. They are:

• The headgear requires over-tightening to retain the same seal
• The headgear is visibly pilling, fraying, or otherwise deteriorating

CPAP headgear typically lasts around six months before requiring replacement, though this varies from case to case. Begin to visually inspect the headgear around the four-month mark during cleaning sessions and replace it if you begin to notice either of the above signs.

CPAP headgear should be cleaned once every one to two weeks or more frequently if you notice acne or breakouts on your scalp. Follow the steps below to clean your Amara View Headgear:

1. Disconnect your Amara View Headgear from the mask frame.
2. Hand-wash the headgear using a mild soap and warm water. Do not use bleach, alcohol, or solutions containing conditioners or moisturizers.
3. Thoroughly rinse your headgear with warm water.
4. Allow your headgear to air dry before reattaching to the mask frame. Do not tumble-dry your Amara View headgear.

Your Amara View headgear should always be hand-washed. Never wash your Amara View headgear in the dishwasher.